Latest H12-811_V1.0 Practice Test Questions Verified Answers As Experienced in the Actual Test!
Pass Huawei H12-811_V1.0 Exam in First Attempt Easily
NEW QUESTION # 11
Which of the following OSPF versions is suitable for IPv6?
- A. OSPFv1
- B. OSPFv2
- C. OSPFv3
- D. OSPFv4
Answer: C
NEW QUESTION # 12
Which of the following messages is used for IPv6 stateless address autoconfiguration? ()*
- A. RS
- B. NA
- C. RA
- D. NS
Answer: A,C
NEW QUESTION # 13
Which of the following commands can be used to view the CPU usage of the router?
- A. display cpu-state
- B. display cpu-usage
- C. display memory
- D. display interface
Answer: B
NEW QUESTION # 14
The CAPWAP control tunnel and data tunnel transmission adopt the same port number.
- A. True
- B. False
Answer: B
NEW QUESTION # 15
The bridge ID of the STP protocol in the switching network is as follows. Which of the following bridge ID switches will become the root bridge?
- A. 32768 00-01-02-03-04-AA
- B. 32768 00-01-02-03-04-BB
- C. 4096 00-01-02-03-04-DD
- D. 32768 00-01-02-03-04-CC
Answer: C
NEW QUESTION # 16
When deploying ACL on Huawei equipment, which of the following descriptions is correct is ().*
- A. The same ACL can be called under multiple interfaces
- B. When ACL defines rules, it can only proceed in the order of 10, 20, 30
- C. When calling ACL under the interface, it can only be applied to the outbound direction
- D. ACL can match the TCP/UDP port number of the packet, and can specify the range of port numbers
- E. ACL cannot be used to filter OSPF traffic, because OSPF traffic does not use UDP protocol encapsulation
Answer: A,D
NEW QUESTION # 17
The network administrator finds that a certain port of the switch has learned the MAC address, but it cannot forward data frames. Which of the following working statuses is this port in?
- A. Learning
- B. Disabled
- C. Blocking
- D. Listening
Answer: A
NEW QUESTION # 18
On an interface that uses PPP as the data link layer protocol, you can configure a static route by specifying the next hop address or outgoing interface. ()
- A. False
- B. True
Answer: B
NEW QUESTION # 19
The processing behavior of the data frame received by the switch is ()
- A. Forward from the receiving port
- B. Forward
- C. Throw away
- D. Flooding
Answer: B,C,D
NEW QUESTION # 20
After the link authentication is completed, the STA will continue to initiate link service negotiation. Which of the following messages is used to achieve the specific negotiation?
- A. Association
- B. Negotiate
- C. Join
- D. Handshake
Answer: A
NEW QUESTION # 21
ip route-static.10.0.2.2255.255.255.25510.0.12.2 preference20, the correct statement about this command is ()
- A. The NextHop of this route is 10.0.12.2
- B. This route can guide the forwarding of packets with the destination P address of 10.0.2.2.
- C. This route can guide the forwarding of packets with the destination IP address 10.0.12.2
- D. The priority of this route is 20
Answer: A,B,D
NEW QUESTION # 22
Which of the following statements about the default route are correct?
- A. If the destination address of the message cannot match any other routing entries in the routing table, the router will forward the message according to the default route
- B. The default route can only be manually configured by the administrator
- C. There must be a default route in the routing table of any router
- D. In the routing table, the default route appears in the form of a route to the network 0.0.0.0 (the mask is also 0.0.0.0)
Answer: A,D
NEW QUESTION # 23
Which of the following statements about link aggregation are correct? ()
- A. GE electrical interfaces and GE optical interfaces cannot be added to the same Eth-Trurnk interface
- B. When two devices are connected, it is necessary to ensure that the link aggregation mode on both devices is the same
- C. Eth-Trurnk interfaces cannot be nested
- D. GE interface and FE interface cannot be added to the same Eth-Trunk interface
Answer: C
NEW QUESTION # 24
By default, the bridge priority of Huawei switches is 32768.
- A. False
- B. True
Answer: B
NEW QUESTION # 25
The priority of the LACP protocol is shown in the figure. Switch A and Switch B adopt LACP mode link aggregation. And all interfaces join the link aggregation group. At the same time, set the maximum number of active ports to 3. Then which port of switch A is not the active port?
- A. G0/0/0
- B. G0/0/2
- C. G0/0/3
- D. G0/0/1
Answer: C
NEW QUESTION # 26
Which statement about the 0SPF protocol DR is correct? ()
- A. DR must be the highest priority device in the network
- B. DR election is preemptive
- C. Router ID, the larger the value, the more preferred it is to be elected as DR
- D. An interface priority is 0, then the interface cannot be a DR
Answer: D
NEW QUESTION # 27
Which of the following working modes does Huawei Enterprise AP support?
- A. FAT
- B. FIT
- C. CLoud
- D. Local
Answer: A,B,C
NEW QUESTION # 28
Which of the following advantages does the single-arm routing method achieve routing intercommunication between Vlan? ()
- A. Reduce the number of chain connections
- B. Reduce the use of IP addresses
- C. Reduce routing table entries
- D. Reduce the number of equipment
Answer: A
NEW QUESTION # 29
......
We offers you the latest free online H12-811_V1.0 dumps to practice: https://prepaway.testinsides.top/H12-811_V1.0-dumps-review.html